Trying to use OME-PIO-D48 PCI card to communicate with Labview. Anysuggestion? - labview

This is a discussion on Trying to use OME-PIO-D48 PCI card to communicate with Labview. Anysuggestion? - labview ; Hi,   I have been trying to communicate with OME-PIO-D48 (OMEGA PCI card) using Labview 8.2.  Although under my device manager I see the card as DAQ card, I can not locate when I run the Measurement and Automation Software ...

+ Reply to Thread
Results 1 to 2 of 2

Trying to use OME-PIO-D48 PCI card to communicate with Labview. Anysuggestion?

  1. Default Trying to use OME-PIO-D48 PCI card to communicate with Labview. Anysuggestion?

    Hi,
     
    I have been trying to communicate with OME-PIO-D48 (OMEGA PCI card) using Labview 8.2.  Although under my device manager I see the card as DAQ card, I can not locate when I run the Measurement and Automation Software of NI.  I also tried to make new device in there, however, I could not see any place to describe the PCI card I have.  I wonder is it possible to use this DAQ PCI card in Labview?
     
    Best regards,
    Olcay

  2. Default Re: Trying to use OME-PIO-D48 PCI card to communicate with Labview.Any suggestion?

    Hi Olcay,

    Thanks for contacting National Instruments. Dennis is correct, Measurement and Automation Explorer (MAX) is a program for National Instruments hardware only. As such, even when you install the OMEGA supplied drivers, your card will not be visible in MAX.

    The driver that is provided by OMEGA will be a library of VIs that you can open in LabVIEW. These VIs will allow you to communicate with and control your PCI card.

    I hope that this helps. Please let me know if you have any further questions. Thanks-

    Mallori M
     
+ Reply to Thread
« Re: power up sequence hardware device | Re: Can I run code written in LabView on machines without thesoftware loaded? »

Similar Threads

  1. Re: Using CEC GPIB PC 488 Card with LabView
    By Application Development in forum labview
    Replies: 0
    Last Post: 11-26-2007, 01:40 PM
  2. does anyone is runing GeoVision card on LabView platform?
    By Application Development in forum labview
    Replies: 1
    Last Post: 11-14-2007, 07:10 AM
  3. Using LabVIEW shared variables to communicate with an Allen BradleySLC500 PLC
    By Application Development in forum labview
    Replies: 1
    Last Post: 11-05-2007, 05:11 PM
  4. Steps to write data into the DAQ Card using LabView
    By Application Development in forum labview
    Replies: 0
    Last Post: 10-26-2007, 05:10 AM
  5. omron cp1h plc communicate with labview
    By Application Development in forum labview
    Replies: 0
    Last Post: 10-01-2007, 08:40 AM