Re: serial communicationThis is a discussion on Re: serial communication within the labview forums in Programming Languages category; I have tried to make a constant from the control (Normal, "\" or hex), but the only thing that works is typing the command into the control. I've also tried a variety of terminator configurations. With the control set to normal display, no terminator characters are neccessary. With the control in the "\" Code display, the command will run as long as I include the \r\n terminator. Here are two .jpgs of the code. vi that does not work.jpg: http://forums.ni.com/attachments/ni/170/293692/1/vi that does not work.jpg vi that works.JPG: http://forums.ni.com/attachments/ni/170/293692/2/vi that works.JPG... | ||||||||
| | ||||||||
| ||||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
#1
01-08-2008, 05:10 PM
| |||
| |||
 Re: serial communication I have tried to make a constant from the control (Normal, "\" or hex), but the only thing that works is typing the command into the control. I've also tried a variety of terminator configurations. With the control set to normal display, no terminator characters are neccessary. With the control in the "\" Code display, the command will run as long as I include the \r\n terminator. Here are two .jpgs of the code. vi that does not work.jpg: http://forums.ni.com/attachments/ni/170/293692/1/vi that does not work.jpg vi that works.JPG: http://forums.ni.com/attachments/ni/170/293692/2/vi that works.JPG  |
 |
| Thread Tools | |
| Display Modes | |
Linear Mode
