LinkBack URL
About LinkBacksThe above post is answered <a href="http://forums.ni.com/ni/board/message?board.id=beta2&message.id=580&jump=true" target="_blank">here</a>
This is a discussion on Re: Blackfin UART Interrupt/Callback for receiving data - labview ; Hi every one! I have a ADSP BF537 EZ kit lite and i would control RF receiver by UART 0. when i program for PC to driver it,&nbsp; everything is OK. and i have checked TX and RX pulse at ...
Re: Blackfin UART Interrupt/Callback for receiving data Hi every one!
I have a ADSP BF537 EZ kit lite and i would control RF receiver by UART 0. when i program for PC to driver it, everything is OK. and i have checked TX and RX pulse at pin 2 and pin3 of DB9 connector, these pulses were smooth.
But when i try driving by ADSP BF537 EZ kit lite using UART 0 with labview embedded for blackfin by using BF UART open VI and BF UART control VI anf BF UART write VI for on/off power only( just send H101) but nothing happened!.
I have checked TX pin, it has output pulse but these pulse are very distort .
Anybody can help me to solve this problem
thank you very much !
Re: Blackfin UART Interrupt/Callback for receiving data The above post is answered <a href="http://forums.ni.com/ni/board/message?board.id=beta2&message.id=580&jump=true" target="_blank">here</a>