Re: Continuous Acq using PXI 6552

Hi,
I'm getting an error as follows.......
Possible reason(s)

river Status:  (Hex 0xBFFA49B5) DAQmx Error -200586 occurred:Measurements: Hardware clocking error occurred.
If you are using an external sample clock, make sure it is connected and within specifications.  If you are generating your sample clock internally, please contact National Instruments Technical Support.
Device:  Dev1
Status Code: -200586

Hi Michael,

In this program I?m generating the 20 MHz signal in digital line 0 and the 1 MHz signal in digital line 1. I?m using this last signal as the sample clock for the acquisition task. In order to do that I physically connected the digital line 1 to the Strobe pin of the card. So I start the generation task and then the acquisition task (that uses the previously generated signal as a clock). I understand that is the reason why this error is showing up, you will need to physically connect digital line 1 to the Strobe. I?m sorry for not explaining this in details previously. I hope this help,

Re: Continuous Acq using PXI 6552 - labview